3com 8807 User Guide

The following command can be used for sending messages between user 
interfaces.

Perform the following configuration in user view.

The following command is used to automatically run a command after you log in. 
After a command is configured to be run automatically, it will be automatically 
executed when you log in again.

This command is usually used to automatically execute telnet command on the 
terminal, which will connect the user to a designated device automatically.

Perform the following configuration in user interface view.

Note the following points:

■

After executing this command, the user interface can no longer be used to 
carry out the routine configurations for the local system. Use this command 
with caution.

■

Make sure that you will be able to log in to the system in some other way and 
cancel the configuration, before you use the auto-execute command 
command and save the configuration.

# Telnet 10.110.100.1 after the user logs in through VTY0 automatically.

[3Com-ui-vty0] auto-execute command telnet 10.110.100.1 

When a user logs on via VTY 0, the system will run telnet 10.110.100.1 
automatically.

Configure to permit call-in and call-out. 

modem both 

Configure to disable call-in and call-out 

Table 25   Configure Modem attributes

Table 26   Configure to send messages between different user interfaces.

Configure to send messages between 
different user interfaces. 

send { all | number | type number }

Table 27   Configure to automatically run the command

Configure to automatically run the command 

auto-execute command text 

Configure not to automatically run the command