3com 8807 User Guide
MBGP Multicast Extension Configuration
495
■
Configure MBGP timer
■
Configure MBGP Peer (group)
■
Configure MBGP route aggregation
■
Configure an MBGP route reflector
■
Configure the MBGP community attributes
■
Configure the interaction between MBGP and IGP
■
Define AS path list and routing policy
■
Configure MBGP route filtering
■
Reset BGP connections
n
Only configuration tasks in IPv4 multicast sub-address family view are detailed
below. Other tasks configured in BGP or system view are only briefed. For the
detailed configuration, refer to the BGP Configuration and IP Routing policy
sections of the Routing Protocol part.
below. Other tasks configured in BGP or system view are only briefed. For the
detailed configuration, refer to the BGP Configuration and IP Routing policy
sections of the Routing Protocol part.
Enabling MBGP
Multicast Extension
Protocol
To enable the MBGP multicast extension protocol, enter the IPv4 multicast
sub-address family view.
sub-address family view.
A router does not start receiving MBFP connection requests instantly after the
MBGP multicast extension protocol is enabled. To activate a router to originate
MBGP connection requests to neighboring routers, refer to the neighbor
configuration. Perform the following configuration in BGP view.
MBGP multicast extension protocol is enabled. To activate a router to originate
MBGP connection requests to neighboring routers, refer to the neighbor
configuration. Perform the following configuration in BGP view.
By default, the system does not run the MBGP multicast extension protocol.
Specifying Network
Routes Notified by
MBGP Multicast
Extension
The network command is used to specify the network routes to be advertised to
MBGP peers, as well as the mask and route policy of this network route.
MBGP peers, as well as the mask and route policy of this network route.
Perform the following configurations in IPV4 multicast sub-address family view.
By default, no route is advertised by the local MBGP.
The network command advertises only the precisely matched route, the one with
prefix and mask completely conforming to the configuration. If no mask is
specified, match goes by the natural network segment.
prefix and mask completely conforming to the configuration. If no mask is
specified, match goes by the natural network segment.
Table 483 Enable MBGP multicast extension protocol
Operation
Command
Enter the MBGP multicast address family view
ipv4-family multicast
Remove the MBGP multicast address family view
undo ipv4-family multicast
Table 484 Specify network routes notified by MBGP multicast extension
Operation
Command
Configure the network routes to be advertised
by the local MBGP
by the local MBGP
network ip-address [ address-mask ] [
route-policy route-policy-name ]
route-policy route-policy-name ]
Remove the network routes to be advertised
by the local MBGP
by the local MBGP
undo network ip-address [ address-mask ] [
route-policy route-policy-name ]
route-policy route-policy-name ]