3com 8807 User Guide
Displaying and debugging VRRP
659
By default, adver-interval is configured to be 1.
Configuring Switch to
Track a Specified
Interface
VRRP interface track function has expanded the backup function. Backup is
provided not only to the interface where the virtual router resides, but also to
some other malfunctioning switch interface. By implementing the following
command you can track some interface.
provided not only to the interface where the virtual router resides, but also to
some other malfunctioning switch interface. By implementing the following
command you can track some interface.
If the interface which is tracked is Down, the priority of the switch including the
interface will reduce automatically by the value specified by value-reduced, thus
resulting in comparatively higher priorities of other switches within the virtual
router, one of which will turn to Master switch so as to track this interface.
interface will reduce automatically by the value specified by value-reduced, thus
resulting in comparatively higher priorities of other switches within the virtual
router, one of which will turn to Master switch so as to track this interface.
When the IP forwarding module (IFM) device is being monitored, the priority of
the switch including the interface will increase automatically by the value specified
by value-increased. When the interface or the IFM device of this interface is Down,
the priority of the switch will decrease by the value specified by value-reduced,
thus resulting in comparatively higher priorities of other switches within the virtual
router, one of which will turn to Master switch so as to track this interface.
the switch including the interface will increase automatically by the value specified
by value-increased. When the interface or the IFM device of this interface is Down,
the priority of the switch will decrease by the value specified by value-reduced,
thus resulting in comparatively higher priorities of other switches within the virtual
router, one of which will turn to Master switch so as to track this interface.
Perform the following configuration in VLAN interface view.
By default, value-reduced is taken 10 and value-increased is taken 2.
n
When the switch is an IP address owner, its interfaces cannot be tracked.
If the interface tracked is up again, the corresponding priority of the switch,
including the interface, will be restored automatically
including the interface, will be restored automatically
You can only track up to eight interfaces in one virtual router.
Displaying and
debugging VRRP
debugging VRRP
After the above configuration, execute display command in any view to display
the running of the VRRP configuration, and to verify the configuration. Execute
debugging command in user view to debug VRRP configuration.
the running of the VRRP configuration, and to verify the configuration. Execute
debugging command in user view to debug VRRP configuration.
Clear virtual router timer
undo vrrp vrid virtual-router-ID timer
advertise
advertise
Table 599 Configure virtual router timer
Operation Command
Table 600 Configure switch to track a specified interface
Operation
Command
Configure the switch to track a specified
interface
interface
vrrp vrid virtual-router-ID track { ifm [
increased value-increased ] | vlan-interface
interface-number [ reduced value-reduced ] }
increased value-increased ] | vlan-interface
interface-number [ reduced value-reduced ] }
Stop tracking the specified interface
undo vrrp vrid virtual-router-ID track [ ifm |
vlan-interface interface-number ]
vlan-interface interface-number ]
Table 601 Display and debug VRRP
Operation
Command
Display VRRP state information
display vrrp [ interface vlan-interface
interface-number [ virtual-router-ID ] ]
interface-number [ virtual-router-ID ] ]