3com 8807 User Guide
Configuration Example
679
Configuration
Example
Example
Network requirements
A host is connected to a Switch 8800 Family series routing switch and appropriate
modules are installed
modules are installed
Network diagram
Figure 159 Diagram for ARP table size configuration
Configuration procedure
# Configure the maximum number of ARP entries supported by the whole switch
to 64K.
to 64K.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] arp enable size 64
The configuration won’t be enable until the system is rebooted
# Configure the maximum number of ARP entries supported by the interface card
in slot 2 to 8K.
in slot 2 to 8K.
[SW8800] arp max-entry 2 8
The configuration won’t be enable until the system is rebooted
# Configure the maximum number of aggregation ARP entries supported by each
interface card in the system to 8K.
interface card in the system to 8K.
[SW8800] arp max-aggregation-entry 8
The configuration won’t be enable until the system is rebooted
Restart the system for the configurations to take effect.
Table 617 Display ARP table size configuration
Operation
Command
Description
Display the current maximum
numbers of ARP entries and
the intending counterparts
that will take effect after the
switch is restarted next time
numbers of ARP entries and
the intending counterparts
that will take effect after the
switch is restarted next time
display arp max-entry
You can carry out the display
command in any view.
command in any view.
console
3&
Switch
console
3&
Switch
console
3&
Switch
PC
LSW
console
3&
Switch
console
3&
Switch
console
3&
Switch
PC
LSW