3com 8807 User Guide

C

HAPTER

 33: BGP C

ONFIGURATION

n 

Perform the following configuration in BGP view.

By default, the BGP does not implement load balancing.

When the switch for adjacency state output is enabled, the BGP adjacency state 
changes will be output to the configured terminal until the switch for adjacency 
state output is disabled.

Perform the following configuration in BGP view.

After the user changes BGP policy or protocol configuration, they must cut off the 
current connection so as to enable the new configuration.

Perform the following configuration in user view.

It is required to re-compute associated route information when BGP routing policy 
changes.

Perform the following configuration in user view.

Table 388   Enable/disable BGP load balancing

Enable BGP load balancing 

balance balance-number 

Disable BGP load balancing 

Table 389   Set the switch for BGP adjacency state output

Enter system view 

system-view 

- 

Enter BGP view 

bgp as-number 

Required 

Enable the switch for 
adjacency state output 

log-peer-change 

The BGP peer changes are not 
reported by default

Table 390   Clear BGP connection

Clear the connection between BGP and the specified peers  reset bgp peer-address 

Clear all connections of BGP 

reset bgp all 

Clear the connections between the BGP and all the 
members of a group 

reset bgp group group-name

Table 391   Refresh BGP routes

Refresh general BGP routes 

refresh bgp { all | peer-address | group group-name } [ 
multicast | vpn-instance instance-name | vpnv4 ] { import 
| export }