3com 7000 Supplementary Manual
ILMI Setup
137
Enable/Disable ILMI
Channel Polling
Enables or disables ILMI channel polling and saves the ILMI channel
polling status for the specified port in the CoreBuilder 7000 family ATM
switch. For more information, “ILMI Connectivity Polling” on page 41 in the Operations Guide.
polling status for the specified port in the CoreBuilder 7000 family ATM
switch. For more information, “ILMI Connectivity Polling” on page 41 in the Operations Guide.
ILMI channel polling must be enabled if the change of attachment-point
facility (COAP) is enabled (see “Enable/Disable Change of
Attachment-Point” on page 148).
facility (COAP) is enabled (see “Enable/Disable Change of
Attachment-Point” on page 148).
To set the polling interval, see “Update ILMI Channel Polling Interval” on
page 139.
page 139.
Command Actions
Command Result
Example
Enter:
1 1 8 5 2
3.2
1
The following message is displayed:
ILMI polling is set to ENABLED
The polling status of port 2 in slot 3 is enabled and is saved to flash.
Enter the menu sequence:
(1) SYS: Platform config
(1) SET: Switch setup
(8) IME: ILMI setup
(5) POL: Polling setup
(2) SST: Set&Save Polling status
Enter a parameter at the prompt
Parameter
Format or Range
Port ID
slot.port
ILMI polling
enable/disable
enable/disable
0
to disable ILMI polling
1
to enable ILMI polling
Direct access sequence:
1 1 8 5 2
[parameters]
System action taken:
ILMI polling for the selected port is updated
immediately and is saved in flash.
immediately and is saved in flash.
System message display:
ILMI polling is set to ENABLED/DISABLED