3com 2928 User Guide
1-12
z
Select GigabitEthernet 1/0/1, GigabitEthernet 1/0/2, and GigabitEthernet 1/0/3 on the chassis front
panel.
panel.
z
Click Apply.
2) Approach 2: Create a dynamic link aggregation group
# Create dynamic link aggregation group 1.
Select Network > Link Aggregation from the navigation tree, and then click Create to enter the page
as shown in
# Create dynamic link aggregation group 1.
Select Network > Link Aggregation from the navigation tree, and then click Create to enter the page
as shown in
Figure 1-7
Create dynamic link aggregation group 1
z
Set the link aggregation interface ID to 1.
z
Select the Dynamic (LACP Enabled) option for aggregate interface type.
z
Select GigabitEthernet 1/0/1, GigabitEthernet 1/0/2, and GigabitEthernet 1/0/3 on the chassis front
panel.
panel.
z
Click Apply.
Configuration Guidelines
Follow these guidelines when configuring a link aggregation group:
z
In an aggregation group, the port to be a selected port must be the same as the reference port in
port attributes, and class-two configurations. To keep these configurations consistent, you should
configure the port manually.
port attributes, and class-two configurations. To keep these configurations consistent, you should
configure the port manually.