3com WX1200 Release Note
16
W
IRELESS
LAN S
WITCH
AND
C
ONTROLLER
MSS V
ERSION
3.0 R
ELEASE
N
OTES
■
set authentication last-resort ssid
any local
any local
■
set authentication last-resort wired
local
local
MSS creates user last-resort-any but does not create
the required last-resort authentication rules.
the required last-resort authentication rules.
If you do not use wired authentication, you can omit
the rule that contains wired.
the rule that contains wired.
Countermeasures Are Service Affecting (18377)
When countermeasures are launched against rogues
and clients of rogues, non-rogue users can experience
interruption as radios go offline to issue the counter-
measures.
and clients of rogues, non-rogue users can experience
interruption as radios go offline to issue the counter-
measures.
Documentation Errata
The following software changes occurred after publi-
cation of the manuals.
cation of the manuals.
No default SNMP community strings (18503)
The 3.0 manuals state that MSS has default commu-
nity strings public and private. This is incorrect. No
community strings are set by default in MSS Version
3.0.
nity strings public and private. This is incorrect. No
community strings are set by default in MSS Version
3.0.
If you want to use these strings, you will need to con-
figure them manually. To configure an SNMP commu-
nity string, use the set snmp community command.
figure them manually. To configure an SNMP commu-
nity string, use the set snmp community command.
The quickstart command prompts for time and date
parameters (18172)
parameters (18172)
The Wireless LAN Switch and Controller Quick Start
Guide on the Documentation CD-ROM states that
time and date parameters must be set manually.
However, the quickstart command prompts you for
these values. You can skip Step 5 on pages 5 and 6 of
that document.
Guide on the Documentation CD-ROM states that
time and date parameters must be set manually.
However, the quickstart command prompts you for
these values. You can skip Step 5 on pages 5 and 6 of
that document.
Revision B of the document, provided in hardcopy
with new orders, is correct.
with new orders, is correct.
STP port path costs are incorrectly documented
(17695)
(17695)
The MSS Version 3.0 manuals do not list the correct
default values for STP port path cost. Here is the com-
plete list of default values for this parameter.
default values for STP port path cost. Here is the com-
plete list of default values for this parameter.
Port Speed
Link Type
Default Port Path
Cost
Cost
1000 Mbps
Full Duplex Aggregate
Link (Port Group)
Link (Port Group)
19
1000 Mbps
Full Duplex
4
100 Mbps
Full Duplex Aggregate
Link (Port Group)
Link (Port Group)
19
100 Mbps
Full Duplex
18
100 Mbps
Half Duplex
19
10 Mbps
Full Duplex Aggregate
Link (Port Group)
Link (Port Group)
19
10 Mbps
Full Duplex
95
10 Mbps
Half Duplex
100