3com S7906E Installation Instruction

 

1-13 

Apply the PoE profile to the current 
PoE interface 

apply poe-profile { index index | 
name profile-name } 

Required 

 

A PoE profile can be applied to multiple PoE interfaces, while a PoE interface can be applied with only 

one PoE profile. 

 

You can upgrade the PSE processing software in service in either of the following two modes: 

z 

refresh mode 

This mode enables you to update the PSE processing software without deleting it. Normally, you can 

upgrade the PSE processing software in the refresh mode through the command line. 

z 

full mode 

This mode deletes the PSE processing software and reloads it. If the PSE processing software is 

damaged (in this case, you can execute none of PoE commands successfully), you can upgrade the 

PSE processing software in full mode to restore the PSE function. 

In-service PSE processing software upgrade may be unexpectedly interrupted (for example, an error 

results in device reboot). If you fail to upgrade the PSE processing software in full mode after reboot, 

you can power off the device and restart it before upgrading it in full mode again. After upgrade, restart 

the device manually to make the new PSE processing software take effect. 

Follow these steps to upgrade the PSE processing software in service: 

Enter system view 

— 

Upgrade the PSE processing 
software in service 

poe update { full | refresh } 
filename pse pse-id 

Required