3M grip-rite 1" 23 gauge pin nails User Guide

This pneumatic fastening tool includes a warning label to help remind you of

important safety information when operating the tool.  The safety label must be
legible at all times, and must be replaced if it becomes worn or damaged.

READ THE MANUAL - The manual contains
important safety and operating instructions
that must be followed.  All tool users must
read the manual before using the tool.

WEAR SAFETY GLASSES - Tool operator
and bystanders must wear safety glasses
with side shield that meet ANSI Z87.1
requirements.

RISK OF PERSONAL INJURY - Failure to
follow all safety and operating instructions,
or misuse of the tool, can result in serious
injury to tool operator and bystanders.

These safety symbols provide a visual reminder of basic safety

rules, and the personal injury hazard that may arise if all safety and

operating instructions are not followed.   Make sure you understand
the meaning of each of these symbols, and protect yourself and

others by obeying all safety and operating instructions.

WEAR SAFETY GLASSES
Always wear safety glasses with side shields that meet ANSI

Z87.1 requirements when operating the tool.  Make sure all

others in work area wear safety glasses.

WEAR HEARING PROTECTION
Wear hearing protection to protect your hearing from noise.

Prolonged exposure to loud noise can result in hearing loss.

BOTTLED GASES
Oxygen and other reactive or high-pressure bottled gases
can cause the tool to explode.  Use clean, dry regulated

compressed air from a properly operating air compressor.

PRESSURE OF 100 PSI /6.9 Bar.
Exceeding the maximum recommended air pressure can

cause the tool housing to burst, or cause premature failure of
components.

NEVER CONNECT THE TOOL TO AN AIR SUPPLY THAT HAS
THE POTENTIAL TO EXCEED 180 PSI/12.4 Bar.
Using a regulated air supply with a line or tank pressure

greater than 180 psi can cause the tool to burst if the air line

regulator fails suddenly.

GREATER
Always use air hose rated to handle 180 psi or the maximum

potential pressure of the air supply.

TION AND YOU ARE READY TO DRIVE  A FASTENER.
When driving is completed, or before reloading, move the
trigger safety lever forward to “SAFE” position.

OPERATING CONTROLS HAVE BEEN MODIFIED OR ARE NOT
WORKING PROPERLY.
Attempting to use a tool with modified or malfunctioning

trigger or safety lever can  result in a  fastener being driven
unintentionally.