3M grip-rite 1" 23 gauge pin nails User Guide

A fastener can be driven unintentionally if the trigger is depressed while
the safety lever is in the operating position .  Always disconnect tool
from air supply before loading fasteners, making adjustments, or per-
forming any service on tool. Always keep safety lever in “safe” position
and finger off trigger until ready to drive a fastener.

1. Disconnect tool from air supply

using quick-connect coupling.

2. Depress magazine latch (A),

and pull magazine cover (B)

back until cover is fully open.

3. Insert fastener strips (C),

placing points down. Fastener

points must be placed into

track at bottom of magazine for

proper feeding and driving.

4. Slide magazine cover closed.

Magazine must click into

latched position.

5. Move trigger safety lever (D)

forward to “safe” position to

prevent trigger from actuating

tool when depressed.

6. Tool is now loaded and ready

to be connected to an air

supply for operation.

1. Disconnect tool from air supply

using quick-connect coupling.

2. Move trigger safety lever (D)

forward to “safe” position to

prevent trigger from actuating

tool when depressed.

3. Depress magazine latch, and

pull magazine cover back until

cover is fully open.

4. Remove fastener strips.
5. Loosen nose door plate (F)

mounting screws, and slide

nose plate down and off nose.

6. Remove jammed fastener.
7. Replace nose plate, and secure

with screws.

8. Reload fasteners, and close

magazine cover.

9. Tool is now loaded and ready to

be connected to air supply.

3. Place nose of tool against

workpiece, positioning nose for

desired fastener driving posi-

tion.

4. Depress trigger to drive a

fastener, and release trigger.

Lift tool from workpiece.

5. Repeat steps 3 & 4 for each

fastener to be driven.  Adjust air

pressure as needed to provide

consistent fastener drive.

Check reload indicator window

(E) periodically to make sure

tool doesn’t run out of fasten-

ers.

6. Move trigger safety lever (D)

forward to “safe” position after

desired fasteners have been

driven, or before reloading.

7. Disconnect tool from air supply

when done fastening.

1. Connect tool to air supply

using quick-connect coupling.

2. Position tool over work surface,

and move trigger safety lever

(D) backward to permit trigger

to actuate tool when de-

pressed.