BacktoBasics cm300 Instruction Manual

Page of 76
 
 
5
4.  Replace the lid on to the mixing container, making sure that the lid covers the 
pour spout. 
5.  Plug the Hot Drink Maker into a 120 volt, AC outlet only
6.  Press the “ON” switch.  Your Hot Drink Maker will begin to mix and heat.  When 
the mixture reaches the “Perfect Temperature” the appliance will automatically 
go idle.  At anytime during the mixing and heating process, you may press the 
“OFF” switch to turn the appliance off.  Note:  A full 32 ounces takes 
approximately 6-8 minutes. 
7.  Once the appliance automatically goes idle, place a cup underneath the 
dispensing valve and press the “FROTH/DISPENSE” switch.  This switch will 
mix the beverage while you dispense so that a rich layer of froth is dispensed 
into your cup along with the hot drink. 
8.  Press down on the dispensing valve lever to dispense the hot drink into your cup 
while the motor is mixing the beverage.  After dispensing the beverage, press 
the “CANCEL” switch. 
9.  When the container has less than 1 cup of liquid remaining or is empty, press 
the “OFF” switch.  Note:  The appliance will remain on until you switch it off. 
 
INGREDIENTS CHART 
CUPS 
1 2  3  4 
LIQUID 
Milk/Water 
8 oz. 
16 oz. 
24 oz. 
32 oz. 
POWDER MIX 
with Milk 
2 tbsp. 
4 tbsp. 
6 tbsp. 
8 tbsp. 
POWDER MIX 
with Water 
4 tbsp. 
7 tbsp. 
11 tbsp. 
14 tbsp. 
 
Note:
  Different instant cocoa, coffee, and tea mixes may vary from the quantities 
shown in this chart.  Use the quantities specified on the packaging of the specific 
instant hot drink mix for exact measurements. 
 
 
“PERFECT TEMPERATURE” FEATURE 
The Cocoa~Latte
 Hot Drink Maker is designed to maintain the “perfect 
temperature.”  Once the hot beverage reaches the “perfect temperature,” you will 
hear the motor stop running and the mixing paddle stop mixing.  The appliance is 
now idle but still “ON.”  Once the hot beverage cools down, the unit will automatically 
reheat and remix back to the “perfect temperature.”  You may at any time press the 
“OFF” switch to turn the unit off.  THE APPLIANCE WILL CONTINUE TO CYCLE 
ON and OFF UNTIL THE “ON/OFF” SWITCH IS TURNED TO THE “OFF” 
POSITION.