X10 vr30a  Owner's Manual

If a DBS Receiver or other A/V
component is connected to the TV using
A/V cables, you can connect the Audio/
Video Receiver to the free LINE IN jacks
on the component. If there are no LINE
IN jacks, you will need to use a TV
antenna splitter as described earlier.

1. Connect a set of Audio/Video cables to

the A/V OUT jacks on the Audio/Video
Receiver. Connect the other end to
your TV (use Yellow for video, and
either L or R channel for audio).

2. Plug the Audio/Video Receiver's Power

Supply jack (the larger power supply
than the one used for the Sender) into
the Audio/Video Receiver and plug the
power supply into a 120 volt wall outlet.

3. Turn the Audio/Video Receiver's power

switch (on side of unit) on.

4. Set the channel switch to the same letter as you set on the Video

Sender, A, B, C, or D.

5. Position the Audio/Video Receiver in a convenient location such as on

top of the TV and orient the antenna so that the flat side points in the
direction where you set up the Video Sender.

You can use the supplied coaxial cable to connect the TV OUT socket on
the Audio/Video Receiver to the Antenna input on your TV.

If you already have an
antenna connected to
your TV, you will need to
use a TV antenna
splitter. Set your TV and
the TV Channel switch
on the Audio/Video
Receiver (on bottom) to
the same channel (3 or
4).

Just hook up the Video Sender using only the red and white jacks for the
right and left channels of the audio signal. Leave the yellow (video) jack and
COAX cable unconnected.