Xanté accel-a-graphix ct4 User Guide

 Warning!

Changes or modifications to this unit not expressly
approved by the party responsible for compliance could
void the user’s authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment
in a residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.

Shielded cables must be used with this unit to ensure compliance with the
FCC Class A limits.

Engine:  115/ 230 volts; 7A/4A; 805/ 920 watts

The power cord is the main disconnect device. It should be plugged into an
easily accessible outlet.

The power cord to be used with 115 Volt configuration is minimum type
SJT (SVT) 18/3, rated 250 Volts ac, 10 Amps with a maximum length of 15
feet. One terminated in an IEC 320 attachment plug. The other end is
terminated in a NEMA 5-15P plug.

The power cord to be used with 230 Volt configuration is minimum type
SJT (SVT) 18/3, rated 250 Volts ac, 10 Amps with a maximum length of 15
feet. One terminated in an IEC 320 attachment plug. The other end is
terminated as required by the country where it will be installed.