Xerox 4112 User Guide
Xerox 4112/4127 Copier/Printer System Administration Guide
1-17
1. Product Overview
Setting the IP address.
In an environment with DHCP or BOOTP, configure the way to
obtain the address. If the address cannot be obtained
automatically or manual configuration is preferred, configure the
IP address, subnet mask, and gateway address.
1.
Enter the System Administrator Mode (Chapter 1 Entering the
System Administrator Mode on page 1-15) if necessary.
System Administrator Mode on page 1-15) if necessary.
2.
Select
System Settings
and then select
Connectivity &
Network Setup
.
3.
Select
Protocol Settings
.
4.
Select
IPv4 - Address Resolution
and select
Change
Settings
.
5.
Select one from
DHCP
,
BOOTP
,
RARP
,
DHCP/Autonet
or
Static
. If you select anything other than
Static
, proceed to
step 10.
NOTE: When using a DHCP server, also configure the WINS
(Windows Internet Name Service) server.
(Windows Internet Name Service) server.
6.
Select
IPv4 - Get IP Address
and select
Change Settings
.
7.
Enter the IP address using the numeric keypad.
NOTE 1: Enter addresses in the format "xxx.xxx.xxx.xxx"
where xxx should be a numeric value in the range from 0 to
255. However, 224 or 225.xxx.xxx.xxx and 127.xxx.xxx.xxx
cannot be used.
where xxx should be a numeric value in the range from 0 to
255. However, 224 or 225.xxx.xxx.xxx and 127.xxx.xxx.xxx
cannot be used.
NOTE 2: When you make an entry mistake, press the C
(Clear) button and enter again.
(Clear) button and enter again.
NOTE 3: When you would like to move to the next value
without entering all 3 digits, select Next.
without entering all 3 digits, select Next.
8.
Select
Save
.