Xerox 4112 Software Guide
X e r o x 4 11 2 / 4 1 2 7 P o s t S c r i p t U s e r G u i d e
5 -15
5 . M a c i n t o s h c o m p u t e r s
Settings
This section describes the settings in the Printer Specific Options
list. The settings that can be selected vary depending on which
options have been installed. Make these settings after specifying
the installed options in Configure.
list. The settings that can be selected vary depending on which
options have been installed. Make these settings after specifying
the installed options in Configure.
Offset Stacking
The position of individual jobs or sets of copies are shifted to either
side of the output tray to enable easy separation.
side of the output tray to enable easy separation.
Collated
Selects whether to collate a multiple-page file per set when they
are printed.
are printed.
Feed Separators from
Specifies the paper tray that transparency dividers are to be fed
from. When [Auto] is selected, the tray set on the machine is used
as the feed destination.
from. When [Auto] is selected, the tray set on the machine is used
as the feed destination.
Print on Separators
Specifies whether or not to print on the transparency dividers as
well as the transparency.
well as the transparency.
Front Cover
Specify whether to add front cover to the printouts. Select the
paper tray for feeding the front cover sheets.
paper tray for feeding the front cover sheets.
Back Cover
Specify whether to add back cover to the printouts. Select the
paper tray for feeding the back cover sheets.
paper tray for feeding the back cover sheets.
Tray 8 - Specify Tab Stock
Specifies whether tab stock is being loaded in tray 8. Select either
"Plain" or "Tab Stock."
"Plain" or "Tab Stock."
Stapling
Specifies whether or not to staple printed documents and the
position of the staple. You can staple 2 to 50 sheets of 80 g/m
2
or
lighter paper.
Hole Punching
Select the punching position. The holes are made based on the
output orientation of the paper. As a result, the holes may not be
punched correctly depending on the position of the image.
output orientation of the paper. As a result, the holes may not be
punched correctly depending on the position of the image.
Hole Punching
Specify the number of holes to punch. Select from "Use Printer
Settings," "2 Holes," or "4 Holes." If "3 Holes" is selected for "Hole
Puncher Setup," only "Use Printer Settings" will be available for
selection.
Settings," "2 Holes," or "4 Holes." If "3 Holes" is selected for "Hole
Puncher Setup," only "Use Printer Settings" will be available for
selection.