Xerox 65 Software Guide

To collect data locally, you will need: a 9-pin serial throughput cable and a valid User Number. 

 

1.  Locate and open the 3-inch by 3-inch cover at the left rear of the Document Glass cover to 

expose two connectors – the smaller one is the 9-pin serial connector. 

 
2.  Connect a 9-pin serial throughput cable between the serial connector on the machine and the 

PC. This cable will have rectangular connectors on both ends. 

 

3. Select 

Start, then Programs, and Auditron Report Software to open the Connection 

Selection window. 

 
4. In 

the 

Connection Selection window, select Local. 

 

If this is the first time this program has been used, the Connection Selection window will 
display the default assignments for Local Setup and Remote Setup. Check that the Local 
Setup assignment is correct for your computer. Refer to Setup Tips at the end of this 
document to determine the port used by your computer’s spare serial connection. 

5. Select 

OK.  The PC window will briefly display the configuration of the CopyCentre 

C65/C75/C90 WorkCentre Pro 65/75/90 in the Connection Manager window. Select Close 
if the Connection Manager screen has not been set to close automatically.  If you want the 
screen to automatically close, check the Auto Close box. 

 

If the PC is not connected to the CopyCentre C65/C75/C90 WorkCentre Pro 65/75/90 at this 
time, a window will briefly appear with a message to check the connection.  The software 
will continually attempt to establish communications.  If a successful connection has not 
been made within five minutes, the software will cease trying and will leave a window with a 
request to Core Functionality not detected, please try again.

 

 

8