Xerox 4510 User Manual
P C L M e n u
3-26
❖
4 5 0 5 / 4 5 0 5 p s o r 4 5 1 0 / 4 5 1 0 p s U s e r ’ s G u i d e
Page Protection
Off*
A4 (210x297)
Legal (8.5x14)
Letter (8.5x11)
Legal (8.5x14)
Letter (8.5x11)
See
Figure 2.3 (page 2-6)
for more paper
dimensions.
dimensions.
Use to reserve memory for a full page of the selected
paper size.
paper size.
When
Off
, memory is not reserved for an entire page.
It then becomes possible for a page to be too complex
to compose. The result is a
to compose. The result is a
Page Too Complex
error message and the page may be printed on more
than one sheet of paper.
than one sheet of paper.
When set to a paper size, each page is composed into
reserved memory before the paper starts to move
through the printer. The printer may slow down
slightly with
reserved memory before the paper starts to move
through the printer. The printer may slow down
slightly with
Page Protection
; however, you will be
assured of printing a complex page on one sheet of
paper.
paper.
Page Protection
can be overridden by software
when the Xerox printer driver is installed.
See
“Printer Settings that Affect Memory” (page 3-67)
for further information.
Jam Recovery
Note: The default for Jam
Recovery is
Recovery is
On
for
firmware release 4.0. The
default is
default is
Off
(as shown at
right) for releases > 4.0. To
determine the firmware
release of your printer,
print a Configuration
Sheet.
determine the firmware
release of your printer,
print a Configuration
Sheet.
Off*
On
Determines how the printer recovers from a paper
jam. It is set independently for PCL and PostScript.
jam. It is set independently for PCL and PostScript.
When
On
, the printer reprints any pages in the printer
at the time of the jam, after the jam has been cleared.
The printer does this by using a portion of memory to
store data. This setting can reduce printer speed with
minimum memory installed. Printer speed can be
increased by installing additional memory and/or
using the default setting of
The printer does this by using a portion of memory to
store data. This setting can reduce printer speed with
minimum memory installed. Printer speed can be
increased by installing additional memory and/or
using the default setting of
Off
.
When
Off
, some pages may be lost after the jam has
been cleared. The print job must be resent, specifying
those pages that did not print as a result of the paper
jam.
those pages that did not print as a result of the paper
jam.
See
“Printer Settings that Affect Memory” (page 3-67)
for further information.
Figure 3.10 PCL Menu options showing factory settings
(continued)
Option
Setting
Description
AUG-CH03 Page 26 Black,Red,Cyan Friday, February 3, 1995 12:22 AM