Xerox 721 Service Manual

USER MODES

XEROX WIDE FORMAT 721P PRINTER OPERATOR MANUAL

User Mode 3 (Low Power Saver Mode) “U3”

If the Low Power Saver Mode is enabled, the printer reduces
power to the Printer Fuser Assembly from 178

°C to 100°C after a

predetermined period of inactivity. If the printer does not receive a
print job or copy job for the time selected in this mode the printer
will enter the Low Power Saver Mode to save power consumption.

If a print or copy job is detected by the printer, the printer will then
enter the Warm up Mode prior to the start of the job to heat the
Fuser Assembly to 178

°C.

The green LED Light inside of the Menu Button flashes when the
printer is in a power saver mode.

1. To enter User Mode 3:

Press the [Menu] Key 3 times when the printer is in the Standby
(idle) Mode.

The [Menu] Key lights green and the Status Display indicates “U3"
flashing on the left side of the display. The right side of the display
shows the current setting (in minutes).

2. Press [Enter]

The status (on or off) is displayed. If the status is off, Low Power
Saver is disabled.

To change the status, press [Enter] and then the [ --> ] Key or the
[ <-- ] Key.

3. Press [Enter] again for access to the time interval.
The current setting (in minutes) is displayed.

The selectable ranges are 10, 15, 20, 30, 40, 50, 60, 90, 120, 180
and 240 minutes. (Factory default is On and set to 15 minutes)

To change the time, press the [ --> ] Key to increase) and the
[ <-- ] Key to decrease, then press [Enter] to save the data.

Enter

Online

Press [Menu] 3 times

Enter

Online

Enter

Online