Xerox 5252 User Guide
DocuColor 5252 System Administration Guide
12
2-1
2 T
o
o
ls M
ode
2.
Tools Mode
Key point:
Some features or options described in this chapter
may not display or be selectable depending on the configuration of
your machine.
your machine.
Overview
The Tools Mode enables you to establish the default settings for
your digital press, with or without a scanner, to fit your individual
requirements. You can change the settings for a variety of
features, such as the initial screen to display when the press is
powered on, the language to display on the Touch Screen, special
paper sizes that can be used in certain Paper Trays, timers, audio
tone controls, default settings for scanner features, image quality
settings, and more.
your digital press, with or without a scanner, to fit your individual
requirements. You can change the settings for a variety of
features, such as the initial screen to display when the press is
powered on, the language to display on the Touch Screen, special
paper sizes that can be used in certain Paper Trays, timers, audio
tone controls, default settings for scanner features, image quality
settings, and more.
Entering and exiting Tools Mode
Key points:
•
If you attempt to access the Tools Mode while a job is printing,
access to the screens will be delayed until the job completes
printing.
access to the screens will be delayed until the job completes
printing.
•
Jobs will queue, but will not print while the Tools Mode is
active.
active.
•
You cannot access the Tools Mode if the digital press is in a
Fault condition.
Fault condition.
•
You cannot access the Tools Mode if the Pause key on the
Control Panel has been pressed to halt a job. When the job
that was stopped has been completed, Tools Mode may be
accessed.
Control Panel has been pressed to halt a job. When the job
that was stopped has been completed, Tools Mode may be
accessed.