Xerox 4517 User Guide
I n s t a l l i n g a n d R e m o v i n g P r i n t e r O p t i o n s
C-4 ❖ D o c u P r i n t 4 5 1 7
/
4 5 1 7 m p U s e r G u i d e
Memory
SIMMs
This section contains two sets of instructions:
•
“Installing a Memory SIMM” (page C-4)
•
“Removing a Memory SIMM” (page C-7)
Installing a
Memory SIMM
Note
Memory SIMMs for the DocuPrint 4517 are available in the
following sizes:
•
one-sided 4 MB and 16 MB
•
two-sided 32 MB
(See Appendix A: Ordering Printer Options for ordering
additional memory.)
Caution
SIMMs and controller boards are sensitive to static electricity.
Before installing a SIMM, discharge static electricity from
your body by touching something metal, such as the metal
back plate on any device plugged into a grounded power
source. If you walk around before finishing the installation,
again discharge any static electricity.
Before installing a SIMM, discharge static electricity from
your body by touching something metal, such as the metal
back plate on any device plugged into a grounded power
source. If you walk around before finishing the installation,
again discharge any static electricity.
Never remove the printer controller board while the printer is
plugged in.
plugged in.
Note
Either 1 MB or 4 MB of the printer’s memory (depending on
the version of the printer) may become unusable when
2-sided 32 MB SIMMs are installed (or other non-Xerox
2-sided SIMMs, such as 8 MB or 2 MB). Thus the total system
memory may be less than the sum of resident and SIMM
memory when 2-sided SIMMS are used. To maximize usable
memory, we suggest selecting slot SIMM3 for a 2-sided
SIMM and not using 2 MB SIMMs in slot SIMM2.
chapterc.frm Page 4 Friday, July 11, 1997 9:17 PM