Xerox 4517 User Guide
I n s t a l l i n g a n d R e m o v i n g P r i n t e r O p t i o n s
A p p e n d i x C : I n s t a l l i n g a n d R e m o v i n g P r i n t e r O p t i o n s ❖ C-15
Hard Drive
This section contains two sets of instructions:
•
“Installing the Hard Drive” (below)
•
“Removing the Hard Drive” (page C-18)
Installing the
Hard Drive
Caution
The hard drive and controller board are sensitive to static
electricity. Before installing the hard drive, discharge static
electricity from your body by touching something metal, such
as the metal back plate on any device plugged into a
grounded power source. If you walk around before finishing
the installation, again discharge any static electricity.
electricity. Before installing the hard drive, discharge static
electricity from your body by touching something metal, such
as the metal back plate on any device plugged into a
grounded power source. If you walk around before finishing
the installation, again discharge any static electricity.
Never remove the printer controller board while the printer is
plugged in.
plugged in.
1
Power OFF the printer and disconnect the power cord and any interface cables.
2
Loosen the thumb screws and pull out the
controller board.
3
Place the controller board on a ream of
paper.
chapterc.frm Page 15 Friday, July 11, 1997 9:17 PM