Xerox N2825 User Manual
Quick Step (OS/2 Warp Server V 4.0)
Chapter 7: OS/2 Network Setup
❖
7-5
Troubleshooting
1
Check cables/drops. Are the LEDs active?
2
Print Settings. Check Enabled=ON, IPADDRESS=dhcp/
bootp/static (make sure the IP Address resolution is set
properly. Use DHCP if your network uses a DHCP server to
assign IP addresses. Use RARP/BOOTP if your network uses
BOOTP to assign IP addresses, and use STATIC if you wish
to assign a specific IP address).
bootp/static (make sure the IP Address resolution is set
properly. Use DHCP if your network uses a DHCP server to
assign IP addresses. Use RARP/BOOTP if your network uses
BOOTP to assign IP addresses, and use STATIC if you wish
to assign a specific IP address).
You may set a Static IP Address form the control
panel if your printer has one. If you are connected
to a network with a Xerox CentreDirect External
Print Server (External Ethernet Adapter) then use
ARP or NBMON Utility to set a Static IP Address.
panel if your printer has one. If you are connected
to a network with a Xerox CentreDirect External
Print Server (External Ethernet Adapter) then use
ARP or NBMON Utility to set a Static IP Address.
3
Printer Properties - Using LPD Output Port. WIN-OS2
using LPRMON.
using LPRMON.
4
Watch LPRPORTD Screen - Is there Activity? In printer
input light processing?
input light processing?
5
It may take a few prints before initial quality responds.
Print 10-20 pages first.
Print 10-20 pages first.
6
Refer to the DocuPrint System Administrator Guide for
additional information.
additional information.