Xerox N2825 User Manual
Set An IP Address
Chapter 2: Connecting to Your Network
❖
2-9
Setting from Windows Operating Systems
Perform these steps to enter the IP Address using ARP and
telnet from a Windows OS. Some DocuPrint network
printers do not support telnet. For these printers, enter
the IP address from the Control Panel as described in the
previous section.
telnet from a Windows OS. Some DocuPrint network
printers do not support telnet. For these printers, enter
the IP address from the Control Panel as described in the
previous section.
1
Open an MS-DOS session
2
2 Ping a known IP address on the network by typing ping
x.x.x.x, where x.x.x.x is the IP address of a device on the
network.
x.x.x.x, where x.x.x.x is the IP address of a device on the
network.
This step is required
3
Create a static ARP entry by typing the following
command: arp -s x.x.x.x aa-aa-aa-aa-aa-aa [Enter] where
x.x.x.x is the IP address you are assigning and
aa-aa-aa-aa-aa-aa is the Ethernet Address
command: arp -s x.x.x.x aa-aa-aa-aa-aa-aa [Enter] where
x.x.x.x is the IP address you are assigning and
aa-aa-aa-aa-aa-aa is the Ethernet Address
The Ethernet Address can be found on the
Configuration Sheet. If you are using a
XeroxCentreDirect External Print Server (External
Ethernet Adapter) the Ethernet Address can be
found on a label located on the bottom of the
Adapter.
Configuration Sheet. If you are using a
XeroxCentreDirect External Print Server (External
Ethernet Adapter) the Ethernet Address can be
found on a label located on the bottom of the
Adapter.
4
Type arp -a [Enter]. A list should appear that shows the
host that was pinged and the new entry
host that was pinged and the new entry
Telnet only works if the device is on the same subnet as the
host (i.e. computer or workstation).
host (i.e. computer or workstation).