Xerox 75 User Guide
Installation Planning Guide
Planning for the installation
DocuTech/DocuPrint 75/90 and DocuPrint 75 MX
3-3
WARNING
Do not remove or modify the power cord plug. Do not use a
two-prong adapter to connect the three-prong plug to an
ungrounded receptacle. Personal injury or damage to the
printer could occur.
two-prong adapter to connect the three-prong plug to an
ungrounded receptacle. Personal injury or damage to the
printer could occur.
A typical USA 20 Amperes receptacle is illustrated in
Figure 3-1. USA 20 Amp receptacle
•
The power receptacle for the printer must be within easy
reach of the printer’s 10 ft. (3 m) power cord from the right
rear corner of the printer and the receptacle shall be easily
accessible. Do not use an extension cord.
reach of the printer’s 10 ft. (3 m) power cord from the right
rear corner of the printer and the receptacle shall be easily
accessible. Do not use an extension cord.
•
If a Phone Share device is used an additional 115V AC 15 or
20 Amp power receptacle is required within 6 ft. (1.8 m) of the
PhoneShare device location. For detailed information about
using a Phone Share device, refer to the section, Telephone
line requirements.
20 Amp power receptacle is required within 6 ft. (1.8 m) of the
PhoneShare device location. For detailed information about
using a Phone Share device, refer to the section, Telephone
line requirements.
•
All configurations require one 115 VAC, 3 wire, 15 Amp
receptacle for the outlet strip that provides receptacles for the
controller and its peripheral devices.
receptacle for the outlet strip that provides receptacles for the
controller and its peripheral devices.
•
Use the power strip to connect the telephone line with the
controller external modem. The power strip has two special
surge-suppressor jacks, one labeled “In” and the other
labeled “Out.” From the wall jack, insert the phone line into
the power strip “In” jack. From the power strip “Out” jack,
insert the phone line into the controller external modem.
controller external modem. The power strip has two special
surge-suppressor jacks, one labeled “In” and the other
labeled “Out.” From the wall jack, insert the phone line into
the power strip “In” jack. From the power strip “Out” jack,
insert the phone line into the controller external modem.
Telephone line requirements
NOTE: The telephone line for the Sixth Sense feature must be
an analog telephone line (not a digital telephone line).
an analog telephone line (not a digital telephone line).
•
The Sixth Sense connection requires either a dedicated
analog telephone line or a PhoneShare device to share an
analog telephone line with up to three other devices.
analog telephone line or a PhoneShare device to share an
analog telephone line with up to three other devices.