Xerox 2135 User Guide
Advanced Features and Troubleshooting Manual
119
Networking
Windows NT 4.x Troubleshooting (TCP/IP)
This troubleshooting section assumes:
■
You have loaded a Phaser 2135 printer PCL or PostScript print driver.
■
You have printed and retained a current copy of the Configuration Page.
1.
Verify these items in the Ethernet Menu area of the Configuration Page:
■
IP Address Resolution is set to DHCP, Front Panel, or BOOTP (depending on
your network configuration).
■
Current IP Address is set correctly. (Note this address if it is assigned
dynamically.)
■
Subnet Mask is set correctly (if used).
■
Default Gateway is set correctly (if used).
Check the LPR and AppSocket settings and verify they are set as desired. These
settings are not critical to operation but provide some security and usability features.
settings are not critical to operation but provide some security and usability features.
2.
Verify the PDL in the Ethernet Menu area of the Configuration Page:
■
Interpreters: Auto, PCL or PostScript (depending on your driver).
3.
From the server desktop, use the right-mouse button and select Network
Neighborhood. With the left-mouse button, select Properties from the cascade menu.
4.
The Network dialog should appear. Select the Protocols tab.
5.
Check the list of installed network protocols for the following item:
■
TCP/IP Protocol.
6.
If you have elected to run CentreWare DP, you must have loaded Novell NetWare
Client 32 and a NWLink IPX/SPX Compatible transport protocol component. You
may also discover printers that have been assigned a TCP/ IP address.
7.
As required, click Add and install any components not listed and restart the system.
8.
Once rebooted, select the Start button and Settings, then select the Printers folder.
The printers window should appear.
The printers window should appear.
9.
Verify that you have loaded and selected the correct driver for your printer.
10.
Right-mouse-click on the printer icon and select Properties.
11.
Select the Ports tab.
12.
Verify that the IP Address in the Print to the following port list is the same as the one
from the Configuration Page. If necessary, re-select the TCP/IP number used for your
from the Configuration Page. If necessary, re-select the TCP/IP number used for your
printer.
13.
Start an application and send a print job to the printer. If the printer still does not
print, refer to the Xerox web site at: www.xerox.com/officeprinting/infoSMART.