Xerox 350 User Manual

Regulatory Information and Specifications

9-6

Phaser 350 Color Printer

MSDS for silicone oil

Section I – Product identification

Trade name and Tektronix part number:
Silicone fluid (found in maintenance tray) 006-7912-00

Product use: Used in Tektronix Phaser 350 color printers.

Section II – Information on ingredients

Ingredients
Polydimethylsiloxane

CAS Number: 63148-62-9

Hazardous Ingredients:

None. This is not a hazardous material as defined by the OSHA Hazard
Communication Standard.

Section III – Hazards identification

Potential Health Effects:
Eyes: Direct contact may cause temporary discomfort with mild redness and dryness similar to windburn.
Skin: A single prolonged exposure (24 to 48 hours) causes no known adverse effect.
Inhalation: Not an irritant to respiratory passages.
Ingestion: Swallowing large amounts could cause discomfort

Section IV – First aid measures

Eyes:  Flush immediately with water.
Skin:  Wipe off and wash with soap and water.
Inhalation: Not a likely route of exposure.
Oral:  No first aid should be needed.

Section V – Fire fighting measures

Flammable Properties: Flammable limits not determined.

Flash point:

545

F, minimum open cup.

Fire & explosion hazards:

No unusual hazards known.

Section VI – Accidental release measures

Spill Or Leak: Wipe with absorbent material and dispose in accordance with Federal, State, and Local regulations.

Section VII – Handling and storage

Handling:

No special requirements.

Storage:

No special requirements.

Section VIII – Exposure control – personal protection

Exposure Guidelines:

None established.

Engineering Controls: None needed when used as intended in Tektronix printers.
Eye Protection: None needed.
Skin Protection: None should be needed.
Respiratory Protection: None needed.