Xerox 300x User Guide
4
Editing Profiles
4-12
PhaserMatch
Making densitometry measurements
Note
The Densitometry command is available only in the Expert
Calibration user mode. Refer to page 2-9 for instructions on
selecting this user mode.
Calibration user mode. Refer to page 2-9 for instructions on
selecting this user mode.
Use the Densitometry dialog box to create a color profile in which ink
densities are matched to a target press with values measured using a
reflection densitometer.
densities are matched to a target press with values measured using a
reflection densitometer.
Start with a base or standard TekColor profile, such as Commercial Press or
SWOP Press. Measure the density of each color swatch on a pair of test
prints, one made on your selected target output device (such as a printing
press) and the other made on your Phaser printer. Use filters for each color.
SWOP Press. Measure the density of each color swatch on a pair of test
prints, one made on your selected target output device (such as a printing
press) and the other made on your Phaser printer. Use filters for each color.
1.
Start the Phaser Calibrator application.
2.
Select Densitometry from the Profile menu. The following dialog
box appears:
box appears: