Xerox 4510 User Guide
Configuring the Network Address
Phaser® 4510 Laser Printer
2-6
Dynamic Methods of Setting the Printer’s IP Address
There are two protocols available for dynamically setting the printer’s IP address:
■
DHCP (enabled by default on all Phaser printers)
■
AutoIP
You can turn on/off both protocols using the control panel, or use CentreWare IS to turn on/off
DHCP.
DHCP.
Note:
You can view the printer’s IP address at any time. On the control panel, select
Information
, press the OK button, select
Printer Identification
, and then press the
OK button.
Using the Control Panel
To turn on/off either the DHCP or AutoIP protocol:
1.
On the control panel, select
Printer Setup
, and then press the OK button.
2.
Select
Connection Setup
, and then press the OK button.
3.
Select
Network Setup
, and then press the OK button.
4.
Select
TCP/IP Setup
, and then press the OK button.
5.
Select
DHCP/BOOTP
or
AutoIP
.
6.
Press the OK button to turn the selection
On
or
Off
.
Using CentreWare IS
To turn on/off the DHCP protocol:
1.
Launch your web browser.
2.
Enter the printer’s IP address in the browser’s Address field (http://xxx.xxx.xxx.xxx).
3.
Select Properties.
4.
Select the Protocols folder on the left navigation panel.
5.
Select TCP/IP.
6.
In the BOOTP/DHCP Settings section, set the BOOTP/DHCP option to On or Off.
7.
Click the Save Changes button.