Xerox 4510 User Guide

Use the following procedure at the control panel to reset the TCP/IP configuration to the 
default settings:

Select 

, and then press the OK button.

Select 

, and then press the OK button.

Select 

, and then press the OK button.

Your IPv6-enabled printer has one interface with multiple addresses. The Interface ID appears 
after the prefix. The printer uses the Interface ID when assigning both the Link-Local address 
and automatic addresses that use router-supplied prefix(es). It is not used in addresses supplied 
by DHCPv6. Link-Local addresses are used by nodes to communicate with other nodes on the 
same local network. There are two ways to set the Interface ID:

■

Automatic (default): The Interface ID is identified from the MAC address associated with 
the interface and different for each device.

■

Manual: When using this option, verify that the interface ID is 64 bits (8 bytes) and 
does not contain certain special characters other than colons or valid hexadecimal digits (0 
through 9, a through f, or A through F).

If you change the Interface ID, you are prompted to reset the printer before the changes 

take effect.

The Interface ID can only be set in CentreWare IS.

To set the Interface ID using CentreWare IS:

Launch your web browser.

Enter your printer’s IP address in the browser’s Address field.

Click Properties.

Select the Protocols folder on the left navigation panel, and then click TCP/IP.

Click the TCP/IP (v6) button.

Do one of the following:

■

Select User Interface ID from MAC address.

■

Select Use this Interface ID.

Click the Save Changes button at the bottom of the page.