Xerox 4510 User Guide
Overview of Network Setup and Configuration
Phaser® 4510 Laser Printer
2-2
Overview of Network Setup and Configuration
To set up and configure the network:
1.
Connect the printer to the network using the recommended hardware and cables.
2.
Turn on the printer and the computer.
3.
Print the Configuration page and keep if for referencing network settings.
4.
Configure the printer’s TCP/IP address, which is required to identify the printer on the
network.
network.
■
Windows operating systems: Run the Installer on the Software and Documentation
CD-ROM to automatically set the printer’s IP address if the printer is connected to an
established TCP/IP network. You can also manually set the printer’s IP address on the
control panel.
CD-ROM to automatically set the printer’s IP address if the printer is connected to an
established TCP/IP network. You can also manually set the printer’s IP address on the
control panel.
■
Macintosh systems: Manually set the printer’s TCP/IP address on the control panel.
5.
Install the driver software on the computer from the Software and Documentation
CD-ROM. For information on driver installation, see the section in this chapter for the
specific operating system you are using.
CD-ROM. For information on driver installation, see the section in this chapter for the
specific operating system you are using.
Note:
If the Software and Documentation CD-ROM is not available, you can download the
latest driver from
.
See also:
Advanced Features Guide at