Xerox 750P Installation Instruction

Verify information and finish

After you have entered the configuration information, the Quick Configuration Wizard 
displays the Configured Printer Information dialog box, which reports the information 
you have entered.  

Verify that the information is correct.

■

If the information is correct, click Apply Changes. 

■

If the information is not correct, click Back to return to previous dialog boxes 
and correct the information.  Click Next to return to the Configured Printer 
Information dialog box.  Click Apply Changes.

■

To exit the wizard and return to the Main window without making any changes, 
click Cancel.

After you click Apply Changes, the printer resets; the changes take effect when the 
reset is complete.        

After the reset, you are prompted to print a test page.  It is recommended that you 
print a test page to verify a successful installation. 

Troubleshooting Windows configurations

Printer does not appear in the Main window printer list

Make sure that the printer is turned on and properly connected to the network.  Try a 
different network drop or port.

Make sure that NetWare is enabled on the printer.  This is reported on the printer’s 
Configuration Page in the NetWare field.  For information on enabling protocols, see 
Disabling and Enabling Protocols on page 42.  If you are using bindery emulation, 
make sure that NDS is disabled.  From the PhaserShare Administrator Print Server 
tab, uncheck the Directory Services checkbox.   

If your network uses a router, configure the router to not suppress NetWare SAP 
(Service Advertising Protocol) packets or packets of the frame type the printer is 
using.

Testing from the PhaserShare Administrator

The following steps provide a simple test of the Administrator:

Click Search Options.

In the Search Options dialog box, click the following radio buttons:

■

■

Click OK.