Xerox 790DP User Guide
Xerox Phaser 790 Getting Started
1-1
Setting up the Phaser 790
This chapter contains the hardware installation instructions only. To install
the printer driver software, go to the
the printer driver software, go to the
Network Setup
chapter. To install to the
network software, go to the appropriate chapter for your operating system.
Preparing for the installation
Before you begin the installation of your Xerox Phaser 790, read this entire
section. You must locate an appropriate site for the installation of the Phaser
790 Printer. Reading this section assists you with the decision making
process.
section. You must locate an appropriate site for the installation of the Phaser
790 Printer. Reading this section assists you with the decision making
process.
Selecting a location
WARNING
The wall outlet must be rated for 115 or 240 volts. It must also be protected
for at least 15 amps for 115 volts, or 8 amps for 240 volts. If you are in
doubt about a power source, ensure that a qualified electrician checks the
outlet.
Do not connect any other devices to the wall outlet designated for the Xerox
Phaser 790.
for at least 15 amps for 115 volts, or 8 amps for 240 volts. If you are in
doubt about a power source, ensure that a qualified electrician checks the
outlet.
Do not connect any other devices to the wall outlet designated for the Xerox
Phaser 790.
Install the Xerox Phaser 790 in a location that meets the following conditions:
•
The Phaser 790 has a designated wall outlet.
•
The power cord cannot be stepped on, or be a tripping hazard.
•
The location has a level, stable surface.
DO NOT install the Phaser 790 in a location that has any of the following
conditions:
conditions:
•
In direct sun light
•
Near an air conditioner or heater
•
In a dusty place
•
Near an open flame
•
In a windy place
•
Near water
•
Where it might be subject to
vibration
vibration
•
Near a magnetic field
•
Where abrupt changes in temperature or humidity occur
1