Xerox 790DP User Guide

Xerox Phaser 790 Getting Started

iii

Xerox Corporation reserves the right to change this information without
notice, and makes no warranty, express or implied, with respect to this
information.  Xerox shall not be liable for any loss or damage, including
consequential or special damages, resulting from the use of this information,
even if loss or damage is caused by Xerox negligence or other fault.

Your Phaser 790 and its supplies have been designed and tested to meet
strict safety requirements. These include safety agency examination and
approval, and compliance with established environmental standards. Please
read the following instructions carefully before operating the Phaser 790.

Failure to follow the recommendations in this section may result in personal
injury or rescinding of the machine maintenance agreement.

An improper connection to the Phaser 790 grounding conductor can result in
electrical shock.  Always connect the copier to a properly grounded wall
outlet. If in doubt, have the outlet checked by a qualified electrician.

Never use an extension cord between the copier power cord and an electrical
outlet.

Do not allow anything to rest on the power cord.

Do not place the Phaser 790 where people may step on the power cord.

Follow all warnings and instructions that are marked on or supplied with the
Phaser 790.

Never override or "cheat" electrical or mechanical interlock devices.

Always locate the Phaser 790 on a solid support surface with adequate
strength for the weight of the copier.

Do not use the Phaser 790 near water, wet locations, or outdoors.