Xerox 6030 User Guide
28 Getting to know the WIDE FORMAT COPY SYSTEM
Xerox 6030/6050 Wide Format Copy System
Powering On the Xerox 6030/6050
Wide Format System with Scan
System
Wide Format System with Scan
System
To power on the Xerox 6030/6050 Wide Format System with Scan
System you first must switch on the SCAN SYSTEM and wait for 30
seconds or check that a P is displayed on the status LED in the back of
the SCAN SYSTEM. Then switch on the Xerox 6030/6050 Wide Format,
then the AccXES Print Server.
System you first must switch on the SCAN SYSTEM and wait for 30
seconds or check that a P is displayed on the status LED in the back of
the SCAN SYSTEM. Then switch on the Xerox 6030/6050 Wide Format,
then the AccXES Print Server.
When the SCAN SYSTEM is present, the DDS parameter must be set to
Enabled in order to enable the COPY/SCAN functionality. If the DDS
parameter is set to Disabled, COPY/SCAN functionality will not be
enabled.
Enabled in order to enable the COPY/SCAN functionality. If the DDS
parameter is set to Disabled, COPY/SCAN functionality will not be
enabled.
The default for the DDS parameter is disabled. You must ensure that it
is set to Enabled when powering on the XEROX WIDE FORMAT SCAN
SYSTEM for the first time. For the Xerox 6030/6050 Wide Format you
can set the DDS parameter from the PRINTER SETUP/Miscellaneous
screen of the Web PMT.
is set to Enabled when powering on the XEROX WIDE FORMAT SCAN
SYSTEM for the first time. For the Xerox 6030/6050 Wide Format you
can set the DDS parameter from the PRINTER SETUP/Miscellaneous
screen of the Web PMT.
Refer to the WebPMT Printer Manager Tool
User Guide for more information. After setting the DDS parameter, wait
30 seconds, and then power the system off then on. Once you enable
this parameter, it will remain enabled (even following future software
upgrades).
30 seconds, and then power the system off then on. Once you enable
this parameter, it will remain enabled (even following future software
upgrades).
To switch on the Scan System, press the Power On/Off Switch on the
back of the Scan System to the On (I) position as shown below. Wait for
30 seconds or until a P is displayed on the status LED.
back of the Scan System to the On (I) position as shown below. Wait for
30 seconds or until a P is displayed on the status LED.
SCAN SYSTEM
Power Switch
Power Switch