Xerox 6128MFP User Guide

Ethernet

Specifies the communication speed and the modes of Ethernet.
• Auto (default) 

Automatically detects 10Base Half, 10Base Full, 100Base Half, and 
100Base Full.

• 10Base Half  

Uses 10Base-T half-duplex.

• 10Base Full  

Uses 10Base-T full-duplex.

• 100Base Half  

Uses 100Base-TX half-duplex.

• 100Base Full  

Uses 100Base-TX full-duplex.

TCP/IP/IPV4

Specifies the TCP/IP settings for the network.

Get IP 
Address

Specifies whether to automatically or manually retrieve the IP address.
• DHCP/AutoIP (default) 

Automatically sets the IP address.

• BOOTP 

Uses BOOTP to set the IP address automatically.

• RARP 

Uses RARP to set the IP address automatically.

• DHCP 

Uses DHCP to set the IP address automatically.

• Panel 

You can set the IP address manually by entering it on the 
operator panel.

IP Address, 
Network 
Mask, 
Gateway 
Address

These items are used to check the addresses that have been obtained 
automatically or to specify addresses manually. Enter the address in the 
format of xxx.xxx.xxx.xxx. You can specify values in the range of 0 to 255 
for xxx.
• To set addresses manually, set the Get IP Address to Panel.
• Make sure that you have a unique IP address. A duplicate IP address 

may affect the whole network. For the addresses you need to set 
manually, contact your network administrator.

Protocol

Set Enable when using the protocol. When Disable is selected, the 
protocol cannot be activated.
• LPR (default: Enable)
• Port 9100 (default: Enable)
• FTP (default: Enable)
• SNMP (default: Enable)
• Email Alerts (default: Enable)
• CentreWare IS (default: Enable)
• Bonjour (mDNS) (default: Enable)

Host Access List

Limits the IP addresses that can access this printer.

Initialize NVM

Initializes network data stored in NVM. After executing this function and 
rebooting the printer, all network settings are reset to their default values.