Xerox 123 User Guide

This section describes how to set up USB communication on the machine. The 
following parameters can be set depending on your requirements. These setups must 
be done without the USB cable connected.
This procedure is used to set up the USB communication parameters of the machine.
At the machine, perform these steps.
NOTE: CentreWare Internet Services can also be used to configure the machine. 
Refer to the CentreWare Internet Services chapter of the User Guide.

Display the [System Settings] screen.

NOTE: For more information about how to display the [System Settings] screen, refer 
to the Setups chapter of the User Guide.

Select [Network Settings].

Select [Port Settings].

Select [USB], and [Change Settings].

Select the item to be set, and then select [Change Settings].

Select the required value, then [Save].

Repeat step 5 and 6, if required.

Depending on your requirements, select the following communication parameters on 
the machine.

• Port Status

• Print Mode

• PJL

• Auto Eject Time

• Adobe Communication Protocol
NOTE: Adobe Communication Protocol can be set when the PostScript Kit (optional) 
has been installed.

Before starting Workstation Setup, make sure that the USB cable is disconnected from 
the computer.
Then perform the following steps.

Refer to the HTML document in CentreWare Utilities CD-ROM or document 
provided with the optional PostScript Kit, and install the print drivers for the 
machine on the workstation that will be sending jobs to the machine.

Connect the USB cable to the machine and the workstation.

Continue with Test Print on page 92.