Make sure that no originals are in the ADF. If an original is detected in the
ADF, the machine gives it priority over the original on the scanner glass. To
get the best scan quality, especially for colored or gray-scaled images, use
the scanner glass.

1. Lift and open the scanner lid.

2. Place the original face down on the scanner glass and align it with the

registration guide at the top left corner of the glass.

3. Close the scanner lid.

In the ADF

Using the ADF, you can load up to 50 sheets of paper (75 g/m

, 20 lb bond)

for one job.

When you use the ADF:
•

Do not load paper smaller than 142 x 148 mm (5.6 x 5.8 inches) or
larger than 216 x 356 mm (8.5 x 14 inches).

•

Do not attempt to load the following types of paper:
- carbon-paper or carbon-backed paper
- coated paper
- onion skin or thin paper
- wrinkled or creased paper
- curled or rolled paper
- torn paper

•

Remove all staples and paper clips before loading.

•

Make sure any glue, ink, or correction fluid on the paper is completely
dry before loading.

•

Do not load originals that include different sizes or weights of paper.

•

Do not load booklets, pamphlets, transparencies, or documents having
other unusual characteristics.

1. Flex or fan the edge of the paper stack to separate the pages before

loading originals.

•

Leaving the scanner lid open while copying may affect copy quality
and toner consumption.

•

Dust on the scanner glass may cause black spots on the printout.
Always keep it clean.

•

If you are copying a page from a book or magazine, lift the scanner
lid until its hinges are caught by the stopper and then close the lid.
If the book or magazine is thicker than 30 mm, start copying with
the lid open.