Xerox x2 tech User Manual

The cutter can automatically cut the media from the roll to the 
selected print size after printing is completed. The cutter then stops 
at the left rest position after the cut is completed. 

If the cutter stops without completing the cut cycle due to a media 
jam, e.g., the printer being turned off or a power failure, turn off the 
printer using its power switch.  After correcting the source of the 
problem, turn on the printer’s power switch. The cutter will return to 
the left position. 

 

follow this section. 

 

  

– Do not pull the media while the cutter is cutting. You may

damage the cutter or the print. 

 

There are two cut modes available: 

1.  Normal cut mode 

2.  No cut mode 

Normal weight coated media or film can be cut using the normal cut 
mode. When heavy media or film cannot be cut with the normal 
mode, select the No Cut mode. In the No Cut mode, after printing is 
finished and the media is forwarded, the operator then cuts manually 
using a knife or scissors. The printer halts and waits for the next 
operation. 

To avoid injury, the print job will not start if the printer’s cover is open, 
even if data is sent to the printer.  Use the manual no cut mode 
whenever the media cannot be cut in the normal cut mode.  

The operator can then manually cut the print using an appropriate 
cutting tool.