Gestetner c7528 Operating Guide

Monitoring and Configuring the Printer

218

Use the “access” command to view and configure access control. You can also
specify two or more access ranges.

❖ View settings

❖ Configuration

•

 represents a target number between 1 and 5. (Up to five access ranges

can be registered and selected.)

Example: to specify accessible IP addresses between 192.168.0.10 and
192.168.0.20:

❖ Access control initialization

• Use the “flush” command to restore the default settings so that all access

ranges become “0.0.0.0”.

❒ The access range restricts computers from use of the printer by IP address.

If you do not need to restrict printing, make the setting “0.0.0.0”.

❒ Valid ranges must be from lower (start address) to higher (end address).
❒ Up to five access ranges can be specified. The entry is invalid if the target

number is omitted.

❒ You cannot access Web Image Monitor from a restricted IP address.

Use the “appletalk” command to view and configure Appletalk parameters.

❖ View settings

• [2] means “active” and [0] means “inactive”.

• The default is [2].

❖ Changing PAP timeout configuration

• Timeout value becomes effective.