Gestetner 3245e Operating Guide

Appendix

36

This section describes possible causes of and actions to take for error messages
displayed on the machine's operation panel. Error messages are classified into
three groups: the image data settings, the copier and the Network Delivery scan-
ner.

❒ If an error message that is not described here appears, turn the power off and

on. If this does not clear the error message, take a note of the contents and
number of the error message and contact your sales or service representative.

If an error message appears on the display of the client computer starting a
scan, see P.39 “Type 270 TWAIN Driver Ver.2 Error Messages”.

Cannot detect original size. Check wheth-
er original is placed and select the proper 
size.

• Place the original again.

• Set the original size to be scanned.

Invalid data size. Check the scanning res-
olution.

• Reset the original size to be scanned.

• Lower the resolution value.

• Add the optional memory module.

Memory full. Cannot continue, send the 
existing scanned data or delete, reset and 
repeat the process.

• Reset the original size to be scanned.

• Lower the resolution value.

• Add the optional memory module.

❒ This message appears when the second 

or later pages of the originals cannot be 
scanned. If you want to send the 
scanned pages (up to the previous 
page) only, press 

. This proce-

dure must be completed within about 
15 minutes after the error occurs. If you 
press 

, all the stored data is de-

leted and no data is sent. Scan the re-
maining pages after the memory 
capacity is back to normal.

Memory full. Cannot scan. Scanning has 
stopped the scanned data has been delet-
ed.

• Press 

 and delete the scanned da-

ta.

• Add the optional memory module.