Gestetner 3532 Network Guide

Remote Maintenance by telnet

77

*1

IP address

Use this command to configure SLP
settings.
You can search the NetWare server
using SLP in the PureIP environment
of NetWare5/5.1, 6. To use the slp
command, you can configure the val-
ue of TTL that can be used by the SLP
multi-cast-packet.

❒ The default value of TTL is “1”. A

search is executed only within a lo-
cal segment. If the router does not
support multi-cast, the settings are
not available even if the TTL value
is increased.

❒ The acceptable TTL value is 1 - 255.

Use the wiconfig command to config-
ure IEEE 802.11b settings.

❒ You can make settings when in-

stalling the optional 802.11b inter-
face kit.

❖

❖

❖

❖ View settings

The following command displays
the current IEEE 802.11b settings.

msh> wiconfig
The IEEE 802.11b card information
is displayed.

❒ If the IEEE 802.11b interface is

not working correctly, the IEEE
802.11b card information is not
displayed.

❖

❖

❖

❖ Configuration

route de-
lete {host | 
net} desti-
nation 

Deletes a host/network route 
from the table. Host becomes 
the default.

route get 
{destina-
tion 

Displays only route informa-
tion corresponding to a spec-
ified destination. When the 
destination is unspecified, all 
routing information is dis-
played.

route active 
{host | net} 
destination 

 on/off

You can turn the specified 
destination on or off. Host be-
comes the default.

route add 
default 
gateway 

You can set the default gate-
way address.

route flush

Deletes all routing informa-
tion.

mode 
[ap|802.11adhoc|
adhoc]

You can set Infra-
structure mode (ap), 
802.11 Ad hoc mode 
(802.11adhoc) or Ad 
hoc mode (adhoc).

The default is 
802.11 Ad hoc 
mode.