Gestetner dsm725e Network Guide
Using SmartDeviceMonitor for Admin
45
2
Note
❒ For details about setting restrictions, see SmartDeviceMonitor for Admin
Help.
Configuring the Energy Saver Mode
Follow the procedure below to configure Energy Saver mode.
A
Start SmartDeviceMonitor for Admin.
B
On the [Group:] menu, point to [Search Device], and then click [TCP/IP],
[IPX/SPX] or [TCP/IP SNMPv3].
A list of machines using the selected protocol appears.
Select the protocol of the machine whose configuration you want to change.
If you are using TCP/IP SNMP v3, enter the user authentication.
[IPX/SPX] or [TCP/IP SNMPv3].
A list of machines using the selected protocol appears.
Select the protocol of the machine whose configuration you want to change.
If you are using TCP/IP SNMP v3, enter the user authentication.
C
Select the machine whose settings you want to make.
To make settings for all machines in the selected group, select no machine.
To make settings for all machines in the selected group, select no machine.
D
On the [Group:] menu, point to [Energy Save Mode], point to [Set Individually] to
make the settings for only the selected machine or point to [Set By Group] to
make the settings for all machines in the selected group, and then click [On]
or [Off].
make the settings for only the selected machine or point to [Set By Group] to
make the settings for all machines in the selected group, and then click [On]
or [Off].
E
Quit SmartDeviceMonitor for Admin.
Note
❒ For details about the setting for Energy Saver mode, see SmartDeviceMon-
itor for Admin Help.
Setting a Password
Follow the procedure below to set a password.
A
Start SmartDeviceMonitor for Admin.
B
On the [Group:] menu, point to [Search Device], and then click [TCP/IP],
[IPX/SPX] or [TCP/IP SNMPv3].
A list of machines using the selected protocol appears.
Select the protocol of the machine whose configuration you want to change.
If you are using TCP/IP SNMP v3, enter the user authentication.
[IPX/SPX] or [TCP/IP SNMPv3].
A list of machines using the selected protocol appears.
Select the protocol of the machine whose configuration you want to change.
If you are using TCP/IP SNMP v3, enter the user authentication.
C
In the list, select a machine whose configuration you want to change.