Gestetner dsm735e Operating Guide
Copying
24
2
F
Press the {Start} key.
The machine starts copying.
When placing originals on the exposure glass, press the {q} key after all
originals are scanned.
Copies are delivered face down.
The machine starts copying.
When placing originals on the exposure glass, press the {q} key after all
originals are scanned.
Copies are delivered face down.
Note
❒ Always log off when you have finished using the machine to prevent un-
authorized users from using the machine.
❒ To stop the machine during a multi-copy run, press the {Clear/Stop} key.
❒ To return the machine to its initial state after copying, press the {Clear Modes} key.
❒ To clear entered values, press the {Clear/Stop} key or [Cancel] on the screen.
❒ To confirm settings, press the {Check Modes} key.
❒ To return the machine to its initial state after copying, press the {Clear Modes} key.
❒ To clear entered values, press the {Clear/Stop} key or [Cancel] on the screen.
❒ To confirm settings, press the {Check Modes} key.
Reference
“When the Authentication Screen is Displayed”, About This Machine
“Administrator Tools”, General Settings Guide
“When the Authentication Screen is Displayed”, About This Machine
“Administrator Tools”, General Settings Guide
Interrupt Copy
Use this function to interrupt a long copy job to make urgently needed copies.
Important
❒ You cannot use Interrupt Copy with the scanner function, or when fax origi-
nals are being scanned.
A
Press the {Interrupt} key.
The interrupt key indicator lights.
The interrupt key indicator lights.
B
The machine stops scanning. Remove the originals that were being copied.
C
Place the originals you want to copy.
D
Press the {Start} key.
The machine starts making copies.
The machine starts making copies.
E
When copying is complete, remove the originals and copies.
F
Press the {Interrupt} key again.
The interrupt key indicator goes off.
The interrupt key indicator goes off.
G
Replace the originals that you were copying, and then press the {Start} key.
Following the instructions on the display, replace the originals that you were copying.
Following the instructions on the display, replace the originals that you were copying.
Note
❒ The previous copy job settings are restored. Simply press the {Start} key to
continue copying from where it left off.