Gestetner 27ao User Guide
JOB EDITOR
38 RW-470 CLIENTS
• Mirror
In this area you can set whether the drawing is to be mirrored or
not during plotting. The individual fields mean the following:
not during plotting. The individual fields mean the following:
OFF: The drawing is not mirrored during plotting.
X:
The drawing is mirrored horizontally.
Y:
The drawing is mirrored vertically.
XY:
The drawing is mirrored about both axes simultaneously;
equates to a 180° rotation.
equates to a 180° rotation.
You usually use these settings if the drawing has been scanned
and saved with a mirror inversion. This is especially important if
a transparency has been scanned with mirror inversion to in-
crease the contrast.
and saved with a mirror inversion. This is especially important if
a transparency has been scanned with mirror inversion to in-
crease the contrast.
“Entry“ area
You can read here, which adjustments can be made for an indi-
vidual entry.
vidual entry.
If you want to alter the settings for the individual entries i.e. alter
the drawings, you can do this on the two “Specific“ and “Addi-
tional“ tabs, which can be used to make the same adjustments
as described in the “Defaults“ tabs.
the drawings, you can do this on the two “Specific“ and “Addi-
tional“ tabs, which can be used to make the same adjustments
as described in the “Defaults“ tabs.
To begin altering the settings of an entry you must mark it in the
left-hand entry list. The “Specific“ and “Additional“ tabs are then
opened and can be edited. If you want to change back to the job
settings or defaults, click once on the “Job“ or “Defaults“ button
above the entry list.
left-hand entry list. The “Specific“ and “Additional“ tabs are then
opened and can be edited. If you want to change back to the job
settings or defaults, click once on the “Job“ or “Defaults“ button
above the entry list.