Gestetner 27ao Technical Manual

 SYSTEM 

REQUIREMENTS 

 

RW-470    5 

Please read through the following recommendations carefully. 
They can be very helpful in finding the optimum hardware for 
your needs.  
•  Operating system:  

Microsoft Windows 2000 Professional

 

with ServicePack 1 or 

higher 

•  Processor: 

Pentium III, 800 Mhz or higher. 

•  PCI Bus:  

The PCI bus system must meet up-to-date standards (PCI 2.0 
or higher – 3.3 V or 5 V autoadaptive, maximum load 5 A). 
If your computer does not fulfill this standard, it is possible 
that the plotter controller will not be identified.  

•  Front Side Bus:  

133 Mhz 

•  System memory:  

Use a system memory with at least 256 MB RAM. With this 
system memory, you can plot or scan the maximum drawing 
size. However, a system memory of 512 MB RAM is recom-
mended if you wish to simultaneously plot and scan draw-
ings with maximum drawing size. Simultaneous scanning 
and plotting of smaller formats also enables the use of 
smaller system memory. See also page 6. 

•  Hard drive:  

The hard drive should have at least 10 GB memory. We rec-
ommend not to install the program on that drive where you 
have already installed your operating system. 

•  Network interface/Configuration:  

10/100 Base T Ethernet, the TCP/IP configuration is neces-
sary 

•  RW-470 Controller: 

Physical dimension: 190 mm x 128 mm 
PCB dimension: 174,63 mm x 106,8 mm