ONKYO cr-315 Instruction Manual

 

18

 

• Connect the right speaker to the CD receiver’s right (R) SPEAKERS terminals. Connect the left speaker to the left 

(L) SPEAKERS terminals.

• Connect the positive (+) terminal on each speaker to the corresponding positive (+) terminal on the CD receiver. 

Connect the negative (–) terminal on each speaker to the corresponding negative (–) terminal on the CD receiver. Use 
the red wires to connect the positive (+) terminals.

• Connect only speakers with an impedance of between 

4 and 16 ohms. Connecting a speaker with a lower 
impedance may damage the speaker.

• Be careful not to short the positive and negative wires. 

Doing so may damage the CD receiver.

• Do not connect both speaker cables to the same L or R 

terminals (Fig. 1). Do not connect more than two 
speaker terminals to each speaker (Fig. 2).

—Push-type terminals—
Strip about 10 mm (3/8") of insulation from the ends of the speaker 
cables, and twist the bare wires tightly. Push the lever and insert the 
bare wires. Release the lever. Make sure the terminal is gripping the 
bare wires and not the insulation.

Red wires

Right speaker

Left speaker

Speaker 
cable

—Terminal posts—
Strip about 15 mm (5/8") of insulation from the ends of the speaker 
cables, and twist the bare wires tightly. Unscrew the terminal. Fully 
insert the bare wire, making sure that it’s touching the threaded shaft in 
the center. Screw the terminal tight.

Fig. 1

Fig. 2

CR515,315_En.book Page 18 Wednesday, June 7, 2006 2:36 PM