ONKYO DR-90 Instruction Manual

60

You can customize the supplied remote controller (RC-399M)
to operate your TV.

TV/VCR
(When the switch is set
to DVD RECEIVER, this
button operates the
muting function. See
page 29.)

CHANNEL  /
(When the switch is set
to DVD RECEIVER, this
button is used to select
the preset channels.
See page 27.)

Programming is carried out by copying the signal patterns of
the TV’s remote control buttons.

• Use new batteries for the remote controller and the TV’s remote

control. Using old batteries may result in a failure in programming or
cause the programmed remote controller buttons to operate
improperly.

• The remote controller and most of other remote controls transmit

infrared rays, however, if the other remote control uses another
method, programming is impossible.

• Although six buttons are prepared for operating the TV, the number

of programmable buttons varies depending on the manufacturer and
type of the other remote control.

• Turn off both the DVD Receiver and TV to prevent the units from

undesired operation during programming.

• The remote control buttons on some TVs may have more than one

function; however, only one function can be programmed per button.

• Refer also to the TV’s instruction manual for details on its remote

control operation and other information.

The programmed buttons of the DVD Receiver's remote controller
may lose their data if the batteries become weak or dead, or due to
other causes. In such a case, you need to repeat programming from
the beginning using the TV's remote control. Therefore, keep the TV's
remote control in a safe place even if it is not in use.

The following programmable buttons
control the TV when the switch is set
to TV.

SENDING/LEARNED indicator

DVD Receiver's
remote controller

TV’s remote control

Proceed to the next step within 15
seconds.

The SENDING/LEARNED indicator lights
up.

If the function is successfully copied, the
SENDING/LEARNED indicator goes off.
Repeat steps 3 to 5 to program other
programmable buttons.

If programming has failed because the data
capacity of the programmable button has been
exceeded or other reasons, the indicator flashes
for five seconds.

• If the SENDING/LEARNED indicator doesn’t light up when you

press one of the programmed buttons, reprogram the button.

• If the remote controller operates only at a short distance or there is

a slow response from the TV, check the batteries.
If the batteries are not weak, the pressed button is not properly
programmed. Reprogram the button.

• If the remote controller remains without batteries for 30 minutes or

more, the programmed data will be erased. In such a case, install
new batteries, then reprogram the buttons.

MEMORY

One of the TV’s
remote control
buttons

REMOTE CONTROLLER                                               

RC-399M

POWER ON

Must be 2 in. to 4 in.
(5 cm to 10 cm) apart