ONKYO dv-sp502 Instruction Manual

 

66

 

• There are no batteries in the remote controller.

Install new batteries (page 11).

• The batteries are flat.

Replace with new batteries (page 11).

• The batteries are installed incorrectly.

Check the batteries and correct as necessary (page 11).

• You’re not pointing the remote controller at the DV-SP502/DV-SP502E’s remote sensor.

Point the remote controller at the DV-SP502/DV-SP502E’s remote sensor (page 11).

• You’re too far away from the DV-SP502/DV-SP502E.

Use the remote controller closer to the DV-SP502/DV-SP502E (page 11). The remote controller has a range of 
approximately 16 ft (5 meters).

• A strong light source is interfering with the DV-SP502/DV-SP502E’s remote sensor.

Make sure that the DV-SP502/DV-SP502E is not subjected to direct sunshine or inverter-type fluorescent lights. Relo-
cate if necessary.

• If the DV-SP502/DV-SP502E is installed in a cabinet with colored glass doors, the remote controller may not work 

reliably when the doors are closed.
Open the doors, or use a cabinet without colored glass.

The DV-SP502/DV-SP502E contains a microcomputer for signal processing and control functions. In very rare situa-
tions, severe interference, noise from an external source, or static electricity may cause it to lockup. In the unlikely even 
that this should happen, unplug the power cord from the wall outlet, wait at least five seconds, and then plug it back in 
again.

DV-SP502E_En.book Page 66 Friday, July 16, 2004 3:34 PM