ONKYO TX-NR900 Instruction Manual

24

To use the tuner of TX-NR900/900E, it is necessary to prepare the
supplied FM and AM antennas.

• Adjustment and placement of the FM and AM antennas for

better reception must be done while listening to a station
broadcast.

• If better reception cannot be obtained, then placement of an

outside antenna is recommended.

Assemble the loop antenna as shown in the illustration.

• Refer to “Connecting the AM loop antenna” below for details on

how to connect the loop antenna.

The FM indoor antenna is for indoor use only. During use, extend the
antenna and adjust its orientation until the clearest signal is received.
Fix it with push pins or similar items in the position that will cause
the least amount of distortion.
If the reception is not very clear with the attached FM indoor
antenna, the use of an outdoor antenna is recommended.

The AM loop antenna is for indoor use only. Set it in the direction
and position where you receive the clearest sound. Put it as far away
as possible from the TX-NR900/900E, televisions, speaker cables,
and power cords.
If the reception is not very clear with the attached AM indoor
antenna, the use of an outdoor antenna is recommended.

Hint:
Either of the split ends of the AM antenna can be connected to either
terminal. Unlike speaker cabling, there is no polarity for AM
broadcast signals.